CAN BE DONE!
If you doubted whether it was possible or not... The answer is YES, you can dye it to your liking.
Here your tips:
Choose a normal hair dye. You can use any color available. However, keep in mind that you should only darken human hair wigs. Don't try to lighten them, as the bleach used on lighter colors can weaken the hair in the wig.
Use a volume 20 hair developer. A lower volume could be too weak. A 20 volume developer will allow you to change the color by one or two shades, while a 30 volume developer will allow you to darken the hair further. In most cases, volume 20 developer will be sufficient.
Put on rubber gloves. Gloves protect the skin from irritation and staining caused by the dye. Wear rubber gloves that you don't mind throwing away later.
Mix the dye and developer in a plastic container. Read the dye instructions to see how much you should mix with the developer. Mix with a plastic spoon. Don't worry if the dye looks a little light, as it will darken over time.
If your wig falls below your shoulders, you may need two boxes of dye.
Do not use a metal bowl or spoon to mix the dye . Metal can oxidize, causing it to change color.
Do not use a metal bowl or spoon to mix the dye . Metal can oxidize, causing it to change color.
Wig in dye . Place the wig in the container with the dye. Use your hands to run the dye through the wig and spread it into the layers. Work gently. Do not rub the product hard on the wig.
The dye may drip from the wig . To avoid stains on the furniture, you can put a towel or tarp on it.
Brush your hair. Use a comb or wig brush to distribute the dye through your hair. Make sure to apply the product evenly throughout the wig. This will help dyed hair look more natural.
Leave the wig on for the color to set. Read the product packaging to see how long you should leave it on. In most cases, you will have to wait 30 or 40 minutes. If you can't find this information, check the wig every 10 minutes. When it reaches the correct color, you can wash it.
If you don't have a stand , leave the wig in the container so the color can set. Cover it with plastic wrap.
Wash the wig with shampoo. Use a neutral shampoo for colored hair or wigs. Run the wig under warm water to remove excess dye before lathering with shampoo. Rinse the product when you're done.
Apply conditioner to the ends. This will give extra shine to the wig. Do not apply it near the roots. Otherwise, the hair may fall out. Rinse the conditioner with cold or warm water.
Pat hair dry with a towel. Gently wring out the wig with a towel to remove excess water.
Allow the wig to dry. You can allow it to air dry or use a hair dryer on low power. If you air dry it, leave it on the stand until it dries completely. If you use a blow dryer, run it up and down your hair. Make sure the wig does not get too hot.
IF WHAT YOU WANT IS A LIGHTER COLOR, WE ALSO HAVE WIGS ALREADY BLEACHED SAFELY, THAT WAY YOU CAN APPLY THE DESIRED DYE.